Stop loss: what it is, where to place it, how often it hits

In this article we look at what a stop loss is in trading and how a trailing stop differs from it, how to place a stop loss based on the normal daily price range, why a stop that sits too close gets hit by ordinary market noise, and how stop distance, holding period and a take-profit order fit together.
A stop loss is an order that closes a position when the price reaches a loss level chosen in advance. It caps the loss on a single trade, but it says nothing about where it should sit, and that is where most of the outcome is decided: on Bitcoin, a stop loss 2% below the purchase price was touched within one day in 42.1% of cases and within one week in 74.9%. Even a 15% stop, almost four times the usual daily price swing, was touched within a month in 30.9% of cases.
We got these numbers ourselves. For every day since August 2017 we made a hypothetical purchase of Bitcoin at the start of the day and checked whether the price reached the stop within a day, a week and a month.
What is a stop loss in trading
A stop loss in trading is a pending order to close a position that activates when the price touches a specified level.
For a purchase it sits below the entry price, for a short position above.
Exchanges usually offer two versions. A stop-market order turns into a market order when the level is touched and closes the position at the best available price. Execution is almost certain, but in a sharp move the actual price can be worse than the stop level; this is called slippage. A stop-limit order places a limit order at a set price when triggered. The price is known in advance, but in a fast drop the order may never fill.
The most useful part of a stop loss happens before the trade. Once the exit point is known, the possible loss is known too, and position size can be calculated from it. We described how this fits into overall risk control in our piece on risk management in crypto trading.
Trailing stop: a stop that follows the price
A trailing stop stays a fixed distance from the best price reached since entry and moves up behind it, but never moves back.
Entry at 100, trailing stop 10%. While the price has not risen, the stop sits at 90. The price reaches 130 and the stop moves to 117. If the price then turns down, the position closes at 117, so part of the gain is kept.
A trailing stop shares the weakness of a regular one. If the distance is smaller than the usual price swings, an ordinary daily wave will hit it and close the position in the middle of a move.
Take profit: the order on the other side
A take-profit order is a limit order that closes a position at a preset price above entry for a purchase, or below entry for a short position.
It is often paired with a stop loss so that when one executes, the other is cancelled. The trade then has two known outcomes, and the ratio between the two distances determines how many times in a row you can be wrong without serious damage. We looked at how many losing trades in a row are normal in our article on losing streaks in trading.
How to place a stop loss: start from the normal price range
It makes sense to compare the stop distance with how far the price usually moves in a day; otherwise the stop will be triggered by ordinary fluctuations.
We calculated Bitcoin's daily range: the gap between the day's high and low as a percentage of the opening price. The median over the whole period is 3.93%. On one day in ten the range exceeds 9.21%.
The range shifts from year to year. In 2018 the median was 5.29%, in 2021 5.82%, in 2023 2.77%, and so far in 2026 2.88%. The range adds the move up and the move down, while a stop sits on one side, so it is a guide rather than a boundary. A 3% stop was slightly wider than the usual daily range in 2023 and almost half of it in 2021.
So first look at how far the price usually travels over the holding period, then place the stop beyond that distance, and only then size the position so that the loss at that distance is an acceptable amount. If the stop has to be wide, the position gets smaller rather than the stop tighter.
How often a stop loss triggers: our Bitcoin calculation
Using hourly Bitcoin candles on Binance from August 17, 2017 to October 21, 2026, a 1% stop loss was hit within a week in 86.7% of cases, a 5% stop in 45.2% and a 10% stop in 19.6%.
Every day at 00:00 UTC we made a hypothetical purchase of Bitcoin at the opening price, 3,321 entries in total. For each entry and each stop size we checked hourly lows to see whether the price reached the stop within one day, 7 days and 30 days. We also recorded the price at period end. Fees were not included.

Stop loss | Hit within a day | Within a week | Within a month | Of those hit within a month, price above entry at month end |
1% | 66.5% | 86.7% | 92.5% | 50.9% |
2% | 42.1% | 74.9% | 86.3% | 47.5% |
3% | 27.6% | 63.7% | 79.9% | 43.7% |
5% | 12.5% | 45.2% | 68.9% | 36.9% |
10% | 2.8% | 19.6% | 45.6% | 23.1% |
15% | 1.0% | 9.8% | 30.9% | 12.1% |
For a base: with no stop at all, 54.6% of all entries were up after a month and 53.2% after a week. False triggers, where the loss was locked in but the price ended above entry, made up 50.9% for a 1% stop and 47.5% for a 2% stop. That is almost the base: a tight stop was knocked out mostly by ordinary noise. For a 10% stop the false share is 23.1%, half the base, so real declines hit it.
A stop has a price. With a stop, a trade's result is minus the stop if hit, otherwise the price change by period end. With the same position size, the average month without a stop was +4.95%, with a 2% stop +1.75%, 5% +3.09%, 10% +3.93%. Only 13.6% of trades with a 2% stop ended the month up, against 54.6% without one.
What the price buys is the tail. Without a stop the worst entry lost 59.3% in a month, one entry in twenty did worse than -26.1%, 22.5% of entries ended the month below -10% and 9.3% below -20%. With a stop the loss on a trade is capped at its level, provided the order fills there.
Hold the loss per trade constant instead, sizing the position to the stop, and the picture changes. Average result divided by stop size came to 0.87 of that loss per month for a 2% stop, 0.62 for 5% and 0.39 for 10%; per week 0.30, 0.16 and 0.09. The tight stop earned more per unit of risk but needs a position five times larger than a 10% stop, and fees and slippage, which we left out, hit it harder because it triggers more often. The period was rising; in a flat or falling market the balance shifts.
Stop size and holding period are linked
The longer a position is meant to be held, the further away the stop loss has to sit to avoid being hit by normal movement.
A 5% stop was touched within a day in 12.5% of cases, within a month in 68.9%. If a position is planned for a month but the stop is set by the standards of a single day, noise will decide the result. It helps to convert your stop into daily ranges: divide the distance by the asset's median daily range. In our table a stop of about one range (3-5% against 3.93%) was touched within a month in 69-80% of entries, two and a half ranges (10%) in 45.6%, almost four (15%) in 30.9%.
Stop loss when trading with leverage
When trading with leverage, the stop loss has to sit closer to the entry price than the level at which the exchange forcibly closes the position.
With leverage, a strong move against the position makes the exchange close it on its own. If the stop is further away than that level, it never gets a chance to trigger. The calculation is in our article on leverage and liquidation risk. With high leverage and almost all collateral committed to the position, the exchange's closing level is close, so is the stop, and by our table such a stop triggers often. A smaller position on the same collateral pushes that level further away and leaves room for a wider stop.
More breakdowns of risk, drawdowns and strategy metrics are in the IQSF blog.
This material is for information only and is not individual investment advice.
Frequently asked questions
What is a stop loss in simple terms?
A stop loss is an order that closes a position automatically when the price reaches a set loss level. For a purchase it sits below the entry price, for a short position above it.
How do you set a stop loss?
First estimate how far the price usually moves over the holding period and place the stop beyond that range. Then size the position so that the loss at the stop is an acceptable amount. Bitcoin's median daily range from 2017 to 2026 was 3.93%.
What is a trailing stop?
A trailing stop is a stop loss that stays a fixed distance from the best price and moves along with it when the price goes in the position's favor.
How often does a stop loss get hit?
It depends on the distance and the holding period. Using hourly Bitcoin candles on Binance from August 2017 to October 2026, a stop loss 2% below the purchase price was hit within a week in 74.9% of cases, a 5% stop in 45.2% and a 10% stop in 19.6%.
What is the difference between a stop loss and a take-profit order?
A stop loss closes a position when the price moves against it and limits the loss. A take-profit order closes the position at a preset price in the direction of profit.
Why does the price reverse right after my stop loss is hit?
If the stop is closer than the normal price range, ordinary fluctuations reach it. In our Bitcoin data, of entries stopped out within a week at 1%, 46.2% were above the purchase price on day seven. With a 10% stop the figure was 11.7%. Without a stop, 53.2% of all entries were up on day seven.



